Power Acoustik CPT1-4000D Mono Block 4000 Watt 1 Ohm Stable Class D with Dash Mount Remote Gain Control, Phase Switch and Selectable 45Hz Bass Boost Review
| Product Code | B003CYL7LC |
| Product Rating |  |
| Price | $187.11 |
| Where To Buy | See More Details |
| Customer Review | See More Reviews |
Product Details
- Amazon Sales Rank: #75349 in Car Audio or Theater
- Size: 11.4 x 1.4 x 18.6 inches
- Brand: Power Acoustik
- Model: CPT1-4000D
- Number of items: 1
- Dimensions: 18.60" h x
1.40" w x
11.40" l,
Features
- 1 Ohm Load Stable Class D
- Selectable 45Hz, 6/12dB Bass Boost
- Variable 12dB 20-50Hz Subsonic Filter
- Bridged Synchronization (strap amps together for double power!)
- MOSFET PSU Transistors Regulated PWM Power Supply Three-Way Protection Circuitry (short, thermal & overload) Pre-Amp Outputs 200mV-8V Low Level Inputs
- 1 Ohm Load Stable Class D
- Selectable 45Hz, 6/12dB Bass Boost
- Variable 12dB 20-50Hz Subsonic Filter
- Bridged Synchronization (strap amps together for double power!)
- MOSFET PSU Transistors Regulated PWM Power Supply Three-Way Protection Circuitry (short, thermal & overload) Pre-Amp Outputs 200mV-8V Low Level Inputs
Product Description
Big Power - Small price! Mono Block Features • 1 Ohm Load Stable Class A/B or D • Variable 12dB 50-250Hz LPF • Variable 12dB 20-50Hz Subsonic Filter (Class D) • Selectable 45Hz, 6/12dB Bass Boost • Freqency Response: 15-150Hz • Signal-to-Noise Ratio: 80dB • Total Harmonic Distortion: .5% • 180o Phase Switch (Class D) • Direct 2 ga. Power & 8 ga. Speaker Terminals • Dash Mount Remote Gain Control • Bridged Synchronization (strap amps together for double power!) • Extruded Aluminum Chassis • Black Texture Finish w/ Silver Trim & Cast Metal Badge • MOSFET PSU Transistors • Regulated PWM Power Supply • Three-Way Protection Circuitry (short, thermal & overload) • High Pass, Low Pass, and Subsonic Filters • Pre-Amp Outputs • 200mV-8V Low Level Input
Customer Reviews
Most helpful customer reviews
1 of 1 people found the following review helpful.
Specs say 2200RMS... more like half that...
By Jacob Ehoff
Ok, This is for the CPT1-4000D mono block amp by power acoustik.Acording to their website this amp is 4000 watts peak power.1,200RMS @ 4 OHMs1,700RMS @ 2 OHMs2,200RMS @ 1 OHMs***Power Acoustik products are NOT CEA certified, so what that means is that the numbers they claim their pruducts produce are not actually proven.I tested mine on 2 10" 4OHM Dual voice coil subwoofers Rated at 500RMS each.Wired at 4 OHMs -the speakers sound fine, but was NOT pushing them to their full potential.Wired at 1 OHMs -there was a huge difference, I would say the speakers are being pushed to their max, but keep in mind they're 500rms each so a total of 1000rms. @ 1 OHM this amp claims to be putting out 2,200rms... if it were in fact putting out 2,200rms my speakers would either be blown or burn out after awhile. I've been pounding them for about 2 months now with no problems. So what I'm saying is that this amp only producing about half of what it claims too.I'm not complaining, It gets the job done for me, but I was shopping for double the amount of RMS I needed simply because of all the reviews I've read about amps being underpowered.I have zero guage power wire and ground supplying the amp, so its not being starved of power.
1 of 1 people found the following review helpful.Great for price!
By 18sbb
So far no problems from this amp at all and it seems to put out the rms watts that it says.
0 of 0 people found the following review helpful.Great amp for the money
By trance86
I purchased this because i needed a 1 ohm stable amp. I heard that power acoustic doesnt go by the standard rating system for rms wattage so i bought bigger than i needed and it was the right choice. I was looking for 1800 watts rms @ 1ohm so i got this amp which supposedly gives 2200. I have the gain all the way up, the bass boost all the way up, the subwoofer level on my 4volt alpine deck all the way up and the remote bass boost that comes with the amp turned up to half way and i seem to get what I was looking for out of my 3 13"tw5's. The set screws are really cheap and strip very easily. Had for a couple months with no issues so far. Installed it on my ceiling rather than under my seat to help prevent overheating and so far so good.
